CategoriesLinearSpecialistRotaryGreenAbssac

Machined Calibration Springs

Machined Calibration Springs
Machined springs by Abssac used  as a “bench-mark” to calibrate material testing instruments due to their 100% repeatable linear spring rates.To calibrate and certify for  tension, compression, flexure, fatigue, impact/hardness. Machined springs.
Tuesday 28th August 2012

Filter Press offset coupling does the job

Filter Press offset coupling does the job
.Where there is a need for large parallel offset between rotating shafts with equally large torque requirements - Schmidt offset couplings for printing industry filter press applications are a good fit..http://www.abssac.co.uk/p/Schmidt+Couplings/Schmidt+Offset+Coupling/48/
Wednesday 15th August 2012

Subsea reverser

Subsea reverser
316L stainless steel Self-reversing screw and follower nut custom made to marine specification for subsea applications. http://www.abssac.co.uk/p/Self+reversing+screws/8/.
Friday 10th August 2012

Budgetbeam couplers used in Olympics

Budgetbeam couplers used in Olympics
Low cost BUDGETBEAM couplers used to connect encoders in the opening of the Olympics props - http://www.abssac.co.uk/p/Shaft+Couplings/Budgetbeam+Couplers/63/.
Thursday 9th August 2012

White Paper. Machined Springs vs Wound springs

White Paper. Machined Springs vs Wound springs
Abssac releases a a white paper on the difference between machined springs and wound springs -  http://www.abssac.co.uk/c/Machined+Springs/17/.
Thursday 9th August 2012

Machined Springs created from Thermoplastic Peek

Machined Springs created from Thermoplastic Peek
.http://www.abssac.co.uk/c/Machined+Springs/17/created from Thermoplastic PEEK to allow transparency in X ray devices and still provide high load, constant spring rate, even at high temperature. Please contact the sales department at Abssac for further details. Tel : 01386 421005.
Monday 6th August 2012
x
check for webp support