CategoriesLinearSpecialistRotaryGreenAbssac

Abssac exhibits at METS !

Abssac exhibits at METS !
SuperYacht Exhibtion 2012 Stand - 09.324 -  The world's largest exhibition of equipment, materials and systems for the international marine leisure industry. Celebrating its 25th anniversary, METS/SYP 2012 will be held on 13-14-15 November in the Amsterdam RAI Convention Centrein the Netherlands.
Friday 9th November 2012

Medical Imaging Success

Medical Imaging Success
Abssac is suppying miniature linear guide rails, only 7mm wide, complete with bearing blocks to complment stainless steel  precision lead screws in a medical imaging application..
Saturday 27th October 2012

INJECTION MOULDED SHAFT COUPLINGS

INJECTION MOULDED SHAFT COUPLINGS
Using the latest injection moulding techniques, Abssac is able to supply a low cost one piece, flexible shaft coupling for lower torque lower cost applications The basic UJ  or GJ design consists of a flexible element that can reliably absorb parallel, angular and skewed shaft misalignments.
Tuesday 16th October 2012

ABSSAC Stand C50

ABSSAC Stand C50
The Engineering Design Show opens its doors at the Ricoh Arena tomorrow and we look forward to welcoming you along to our stand C50 -.
Tuesday 9th October 2012

High helix lead screws

High helix lead screws
The cold rolled, wear resistant range of Abssac high helix motion screws provide high linear speeds and deliver an efficiency which is nothing short of impressive. These high-helix lead screws for motion and positional applications can have multi start thread forms up to 10 times the given diameter and provide...
Thursday 20th September 2012

Custom lead screws for nuclear and marine applications

Custom lead screws for nuclear and marine applications
Custom lead screws for nuclear and marine applications with material traced to source using  EN10204 3.1. with full test certification.  Trapezoidal motion screws from the. at Abssac can be created in non-standard materials to specific yield and tensile Mpa requirements with full supporting certification.
Thursday 13th September 2012
x