We go from UTS strength to strength
Our industrial series can withstand a higher tensile load than that of our maximum torque rating. This is due to the unique treatments to raise efficiency of pin and block friction surfaces whilst using higher ultimate tensile strength (UTS) materials than many UJ manufacturers....
Friday 14th December 2012
Schmidt Couplings aid in the manufacture of wind turbine blades
Schmidt offset shaft couplings are used to drive the rubber pull rollers and heated laminating rollers that create a structural adhesive for the manufacture of pre-impregnated composite fibres. Commonly used in the manufacture of wind turbine blades, the advanced composite materials ...
Thursday 6th December 2012
Abssac exhibits at METS !
SuperYacht Exhibtion 2012 Stand - 09.324 - The world's largest exhibition of equipment, materials and systems for the international marine leisure industry. Celebrating its 25th anniversary, METS/SYP 2012 will be held on 13-14-15 November in the Amsterdam RAI Convention Centrein the Netherlands....
Friday 9th November 2012
Medical Imaging Success
Abssac is suppying miniature linear guide rails, only 7mm wide, complete with bearing blocks to complment stainless steel precision lead screws in a medical imaging application.
Saturday 27th October 2012
INJECTION MOULDED SHAFT COUPLINGS
Using the latest injection moulding techniques, Abssac is able to supply a low cost one piece, flexible shaft coupling for lower torque lower cost applications The basic UJ or GJ design consists of a flexible element that can reliably absorb parallel, angular and skewed shaft misalignments....
Tuesday 16th October 2012
ABSSAC Stand C50
The Engineering Design Show opens its doors at the Ricoh Arena tomorrow and we look forward to welcoming you along to our stand C50 -
Tuesday 9th October 2012